Kelayakan Abu Terbang PLTU Buntoi Sebagai Campuran Beton Geopolimer

Feasibility Of Flying Ash Of PLTU Buntoi As A Geopolimary Concrete Mixture

Authors

  • Dadang Suriyana Universitas Palangka Raya
  • Liliana Sahay Universitas Palangka Raya
  • Okta Meilawaty Universitas Palangka Raya

DOI:

https://doi.org/10.33084/mits.v9i2.2063

Keywords:

Abu Terbang, Beton Geopolimer, Geopolimer, NaOH, Na2SiO3

Abstract

The main basic ingredients needed for the manufacture of this geopolymer material are materials that contain a lot of silica and aluminia elements. The 1st stage test was carried out to determine the geopolymer paste with the maximum compressive strength at the ratio of NaOH to Na2SiO3 of 1; 1.5; 2; 2.5. The second stage of testing was carried out using a geopolymer paste with the highest compressive strength, namely the ratio of NaOH to Na2SiO3 of 2.5 with a compressive strength of 22.56 MPa. Based on the results of the compressive strength test, the maximum compressive strength at the age of 28 days is 7.64 MPa. The results of the compressive strength of concrete are much lower than the compressive strength of the paste, it shows that the paste does not bind too much with the aggregate. This is evidenced by the results of the compressive strength of conventional concrete which is much higher than that of geopolymer concrete using the same aggregate. With the results of the maximum compressive strength at the age of 28 days is 29.51 MPa.

Downloads

Download data is not yet available.

Author Biographies

Dadang Suriyana, Universitas Palangka Raya

Student of Civil Engineering, Universitas Palangka Raya

Liliana Sahay, Universitas Palangka Raya

Lecturer of Civil Engineering, Universitas Palangka Raya

Okta Meilawaty, Universitas Palangka Raya

Lecturer of Civil Engineering, Universitas Palangka Raya

References

Davidovits, J., (1994), Membakar 1 Ton Semen Sama Dengan Menghasilkan 1 Ton Karbondioksida. Prancis.
Davidovits, J., (1970), Beton Geopolimer. Prancis.
Davidovits, J., (2012), Aplikasi Geopolimer Berdasarkan Rasio Si/Al. Prancis.
Ekaputri J.J. & Triwulan, (2013), Sodium Sebagai Aktivator Fly Ash, Trass dan Lumpur Sidoarjo Dalam Beton Geopolimer. Fakultas Teknik Institut Teknologi Sepuluh Nopember.
Ferdy., (2010), Pengaruh Temperatur Dan Waktu Curing Terhadap Kuat Tekan Pasta Geopolimer Berbahan Dasar Abu Terbang. Fakultas Teknik Universitas Indonesia.
Liliana, S, & Meilawaty, O, (2018), Komposisi Kimia Fly Ash PLTU Buntoi Kabupaten Pulang Pisau. Palangka Raya.
Meilawaty, O., (2017), Buku Panduan Panduan Praktikum Beton. Fakultas Teknik Universitas Palangka Raya.
Mulyono, T., (2004), Teknologi Beton. Yogyakarta.
Septia, P., (2011), Studi Literatur Pengaruh Konsentrasi NaOH dan Rasio NaOH:Na2SO3, Rasio Air/Prekusor, Suhu Curing dan Jenis Prekursor Terhadap Kuat Tekan Beton Geopolimer. Fakultas Teknik Universitas Indonesia.
Sumajouw dan Dapas, (2012), Penggunaan Sodium Hidroksida dan Sidium Silikat. Manado.
Sukirman, S., (2003), Pengertian Agregat. Palembang.
Tion, F., (2019), Pemanfaatan Abu Batu Bara Sebagai Bahan Campuran Beton Pada Konstruksi Bangunan. Fakultas Teknik Universitas Palangka Raya.
Windah, Sumajouw, & Manuahe, (2014), Kuat Tekan Beton Geopolymer Berbahan Dasar Abu Terbang (Fly Ash), Fakultas Teknik Universitas Sam Ratulangi.
Winter & George, (1993), Material Penyusun Semen. Inggris.
Yuanda, Fadli, & Drastinawati, (2015), Pemanfaatan Limbah Abu Terbang (Fly Ash) Sebagai Bahan Pembuatan Beton Geopolimer. Fakultas Teknik Universitas Riau.

Downloads

Published

2021-06-01

How to Cite

Suriyana, D., Sahay, L., & Meilawaty, O. (2021). Kelayakan Abu Terbang PLTU Buntoi Sebagai Campuran Beton Geopolimer: Feasibility Of Flying Ash Of PLTU Buntoi As A Geopolimary Concrete Mixture. Media Ilmiah Teknik Sipil, 9(2), 102–108. https://doi.org/10.33084/mits.v9i2.2063